Advertisement
Quick Links
How to Remove and Reposition a GE Interlogix Smoke Sensor Model TX-6010-01-1
Description
This page shows how to remove and reposition a GE Interlogix Smoke Sensor Model TX-6010-
01-1
Please read through the directions in its entirety before commencing.
Preparation
***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the
panel on test mode through
1. Tap [Home]
2. Tap [Place on Test]
3. Enter your expiration date and time
4. Enter your password
5. Tap [Yes-Proceed]
Parts Required
1. A Phillips screwdriver
2. Thin sharp knife
myadt.ca. After logging in:
Advertisement
Related Manuals for GE Interlogix TX-6010-01-1
Summary of Contents for GE Interlogix TX-6010-01-1
- Page 1 How to Remove and Reposition a GE Interlogix Smoke Sensor Model TX-6010-01-1 Description This page shows how to remove and reposition a GE Interlogix Smoke Sensor Model TX-6010- 01-1 Please read through the directions in its entirety before commencing. Preparation ***IMPORTANT customers who use myadt.ca*** Before removing the sensor, place the...
- Page 2 Removal of Smoke Sensor 1. Grab the face of the smoke detector and twist to the left to release from the back plate 2. Arm and disarm the alarm to clear panel alert 3. Determine if the back plate is attached with adhesive tape or screwed in a.
- Page 3 5. Arm and disarm the alarm to clear panel alert ***If the alert does not clear or if the panel sensor shows tamper, walk through the steps above once more. It could be the sensor cover is not on properly***...