Removing Paired Devices; Setting Voice Prompt; Setting Tone - Motorola WM800 User Manual

MN010200A01-AC
Chapter 2: WM800 Remote Speaker Microphone
When WM800 RSM turns off unintentionally due to power loss or auto shutdown, WM800 RSM will reconnect
to the paired host when it powers up again.
Connecting to the Same Host
If WM800 RSM is paired through Bluetooth, the connection automatically reestablishes when power up.
If WM800 RSM is paired through Secure NFC, refer to
(recommended for higher security level) on page
Connecting to New Host
WM800 RSM must be in Pairing Mode by pressing Power button and PTT button simultaneously. Refer to
WM800 RSM Pairing on page
2.3.3.2

Removing Paired Devices

Prerequisites: Ensure that your WM800 RSM is turned off.
Procedure:
1. Remove the WM800 RSM from the paired device list on the paired host device.
2. Press and hold the PTT button and the Power button simultaneously for five seconds.
When your WM800 RSM starts clearing the pairing list, you can observe the following sequence:
● You hear the following voice prompts: "Power On", "Pairing Clear"<Battery Status>,
<Connections Status> (if WM800 RSM is set to Voice Prompt).
● "Power On Tone", "Clear Pairing Tone", and "Connections Status Tone" plays (if WM800 RSM is
set to Tone)
● Your WM800 RSM enters the pairing state after clearing paired host devices.
NOTE: WM800 RSM automatically turns off after two minutes in pairing mode.
2.3.4

Setting Voice Prompt

Prerequisites: Ensure that your WM800 RSM is unpaired and not connected to any host device.
Procedure:
1. Press the Two-Dot Programmable button.
2. Select Language or Tone.
2.3.5

Setting Tone

Prerequisites: Ensure that your WM800 RSM is unpaired and not connected to any host device.
Procedure:
1. Press the Two-Dot Programmable button.
2. Select Language or Tone.
32
29.
29.
Pairing Your WM800 RSM Through Secure NFC