Table of Contents
Advertisement
SYSTEM WALK-THRU
GENERAL
AUDIO FEEDBACK
Now that you have successfully "set up" your
Telex Wireless System and turned on your
sound equipment (amplifier/mixer, etc.), you
are ready to test the overall performance by
"walking" the transmitter through the areas in
which you will be using it.
CARRIER INDICATION__
Under normal conditions the Tx on LED indic-
tor will be on at all times when the transmitter
is on.
"Weak Signal" conditions will result in no or
intermittent indication with the potential of ac¬
tually "hearing" this in the sound system.
The "system walk-thru" can detect RF
problems of weak signal strength caused by the
following:
® Poor antenna location
The system walk-thru can also uncover loca¬
tions in the performing areas which are prone
to audio feedback (usually sounds like a
"squeal" or a "howl"). Feedback can be a prob¬
lem for any microphone - whether wired or
wireless.
To eliminate feedback, observe
placement of the microphone and any nearby
loudspeakers.
In 99% of all instances you wiU set up your
Telex Wireless System, walk it through and
achieve error-free performance. If in the rare
instances your Telex System does not "pass"
during your walk-thru evaluation, refer to the
next section, which deals with System
Troubleshooting.
« RF "Trouble Spots"
• Operating distance beyond system
capability
• Old or used transmitter batteries
-22-
Advertisement
Table of Contents
