Boss SX-700 Owner's Manual page 23

Utility Function Parameters
(STANDARD PITCH) (435 - 445Hz)
STANDARD PITCH
A = 440H
=
"Standard pitch" is the frequency of the note A4 (middle A on
a piano) that is used as the standard to which all other notes
are tuned.
With the SX-700, you can set the standard pitch for recogniz-
ing the names of notes input to the Harmonist.
* At the factory settings, this is set to 440 Hz.
(BYPASS MODE) (BYPASS, MUTE)
BYPASS MODE
BYPASS
Specify the result of turning BYPASS On.
BYPASS: Input sounds are output unchanged.
MUTE: — Nothing will be output from any OUTPUT jack;
i.e., the SX-700 will be muted (silent).
* This is set to "BYPASS" when the unit was shipped.
(PARAMETER HELP) (ON, OFF)
PARAMETER HELP
|
When Parameter Help is setto "ON," details about parameter
names appear in the display when you press the VALUE knob
while making Effector settings.
(LCD CONTRAST) (0 - 15)
LOD COHTRAST
Depending on the location of the SX-700, the display may be
difficult to read. In such a case, adjust the display contrast.
(MIDI CHANNEL) (1 - 16) (P.49)
(MIDI OMNI MODE) (OMNI ON, OMNI OFF) (P.49)
(MIDI DEVICE ID) (1 - 32) (P.49)
(MIDI PROGRAM CHANGE RECEIVE) (ON, OFF) (P.49)
(MIDI PROGRAM CHANGE MAP) (P.50)
(MIDI BULK DUMP) (P.51)
(MIDI BULK LOAD) (P.52)
(FACTORY PRESET) (P.55)
This procedure returns (initializes) the SX-700's settings to
their factory-default values. For more information, check out
"Restoring the Factory Settings (Initialization)". (p.55)
Section 2 Modifying Various Settings 23