Page 2
NCR, therefore, reserves the right to change specifications without prior notice. All features, functions, and operations described herein may not be marketed by NCR in all parts of the world. In some instances, photographs are of equipment prototypes. Therefore, before using this document, consult with your NCR representative or NCR office for information that is applicable and current.
Page 3
Table of Contents Solid State Drive Introduction Kit Components 80-GB SSD SATA Kit 120-GB Upgrade Kit 240-GB Upgrade Kit Installation Procedures...
Solid State Drive Introduction This kit contains the components for upgrading the data storage of the NCR N3000 Site Controller. There are three Solid State Drive Kits: • 1676-K080—80-GB SSD SATA Kit • 1657-K120—120-GB Upgrade Kit • 1657-K240—240-GB Upgrade Kit...
Solid State Drive Installation Procedures The NCR N3000 Site Controller has two SATA Solid State Drive slots. Storage media upgrade may involve replacing the pre-installed Solid State Drive or adding a Solid State Drive module. Warning: Internal components of the N3000 platform are ESD sensitive. All proper grounding precautions must be taken before opening the chassis.
Page 7
Solid State Drive To install a Solid State Drive, follow these steps: 1. If applicable, rotate the antennas so that they are parallel to the device. 2. Lay the device face down on a flat surface. 3. Using a Phillips screwdriver, remove the screw on the SSD bracket.
Page 8
Solid State Drive 4. Lift and slide off the bracket from the back cover. 5. If there is a pre-installed Solid State Drive, remove the SSD by following these steps: a. Disconnect the SATA Data and Power cables from the drive.
Page 9
Solid State Drive b. Remove the four screws that attach the Solid State Drive to the bracket. 6. Align the new Solid State Drive to the bracket so that the ports are on the same side of the bracket feet.
Page 10
Solid State Drive 7. Secure the Solid State Drive to the bracket using four screws. 8. Connect the SATA Data and Power cables to the drive.
Page 11
Solid State Drive 9. Slide in the bracket so that the bottom cover feet are on top of the bracket feet, and then push down the SSD bracket. 10. Secure the SSD bracket to the back cover using a screw.