Table of Contents
Advertisement
XE90QRG.BK Page 8 Wednesday, January 5, 2000 9:55 AM
P r o b l e m
Incorrect fonts
Unable to Scan -
Hardware Detect
Error
COPY SERVICE
ERROR
FAX RX IN
MEMORY
LINE ERROR
MEMORY FULL
PAPER SIZE
ERROR SET XXX
SIZE PAPER
PAPER OUT (###)
LOAD
DOCUMENT(S)
NO RESPONSE
RETURN ORG. ##
SHEETS
6.8
U s e r G u i d e
P R O B L E M S A N D S O L U T I O N S
W o r k C e n t r e S u g g e s t e d S o l u t i o n
Use the fonts dialog box in the Control Panel to enable True Type fonts.
For scanning to work, PC must be in ECP mode. Refer to the user guide for
PC - Parallel Port.
Switch OFF the Main Power. Wait approximately 5 seconds. Switch ON the Main
Power. If the message persists, contact Xerox.
A fax has been received in memory because the imaging cartridge needs
replacement, the fax machine has run out of printing paper, or the paper is
jammed. The fax will be printed out automatically once the problem is fixed.
Fax transmission or reception was not successful. Press the Stop key to clear the
message, and then try again.
The memory is full. See Memory in the Fax Special Features chapter of the
Online User Guide.
The setting for the printing paper size is incorrect. Set it correctly. In the area
labeled "XXX", "LTR", "LGL", or "A4" will appear.
The paper has run out and the data is read into memory.
Set the document(s) in the unit.
Line error, or no answer from the receiver.
Paper jam in the SPF.
When the memory is full and there is a line error, the display alternates between
the RETURN ORG. and MEMORY FULL messages.
Advertisement
Table of Contents
