AEG L 62482 NFL User Manual page 14

14 www.aeg.com
10.9 Cancelling the delay start
To cancel the delay start:
1. Press button Start/Pauze to set the
appliance to pause.
The related indicator flashes.
2. Press button Startuitstel repeatedly
until the display shows .
3. Press button Start/Pauze again to
start the programme immediately.
10.10 Interrupting a
programme and changing a
function
You can change only some options
before they operate.
1. Press button Start/Pauze.
The related indicator flashes.
2. Change the function set.
3. Press the button Start/Pauze again.
The programme continues.
10.11 Cancelling a running
programme
1. Turn the programme knob to
cancel the programme.
2. Turn again the programme knob to a
new washing programme. At this
time you can also set the available
functions.
Before starting the new
programme the appliance
could drain the water. In this
case, make sure that the
detergent is still in the
detergent compartment, if
not fill the detergent again.
10.12 Opening the door when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the door lock
indicator
you cannot open the door.
To open the door proceed as follows:
to
stays on and
1. Press the button Aan/Uit for some
seconds to deactivate the appliance.
2. Wait for some minutes and then
open carefully the appliance door.
3. Close the appliance door.
4. Activate the appliance and set the
programme again.
10.13 Opening the door when
the delay start is active
While the delay start operates, the
appliance door is locked.
To open the appliance door:
1. Press button Start/Pauze.
In the display the door lock indicator
goes off.
2. Open the appliance door.
3. Close the door and press button
Start/Pauze.
The delay start continues.
10.14 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display comes on and the door
locked indicator
The indicator of Start/Pauze button goes
off.
1. Press button Aan/Uit to deactivate
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent
mildew and odours
goes off.