Table of Contents
Advertisement
SHOWBOX BATTERY POWERED ALL-IN-ONE PERFORMANCE RIG WITH BREAKAWAY MIX CONTROL
Outdoor Mode Button and LED
Regarding outdoor mode... in a sentence, choose whether you are using ShowBox inside or outside.
The speaker's voicing is altered to the environment. That's all you need to know, but we're going to give you more!
When speakers are outside, a combination of low and high frequencies don't build up the way they do inside.
ShowBox corrects for that by boosting the frequency ranges that become deficient so the speaker sounds
the same outside as when it's inside. You make the selection, we'll do the rest!
Additionally, when outdoor mode is engaged, the LEDs on the breakaway mixer are at full brightness, but are down to around
25-50% brightness when the outdoor mode switch is disengaged.
The outdoor mode LED will illuminate green when engaged (outdoors).
PA Mode Button and LED
The ShowBox works as two kinds of "loudspeakers" with different built-in voicing modes:
Amp(lifier) mode: The default voicing – AMP MODE – is optimized as a busking instrument amplifier.
The EQ curve focuses on clarity in the mid- and high-mid frequency ranges and is optimized around
vocals and guitars. The LED will not be illuminated when in AMP MODE.
PA mode: PA MODE is optimized as a typical "loudspeaker". It is a great selection to choose for when live music has wrapped
up and you simply want to play music through a "PA speaker". The EQ curve focuses on low frequency extension and resembles
a slight smiley EQ curve (scooped mids). The LED will illuminate green when in PA MODE.
Battery Charge Status LED
this LED will illuminate solid green. When the ShowBox is not plugged into a live power outlet and/or the battery
is not charging, this LED will not illuminate.
Factory Reset
When a ShowBox is factory reset, it restores most parameters back to their default. This includes all EQ, FX,
compressor parameters, and auto-connect, among others.
So how does one place the ShowBox back to its factory default? With the ShowBox powered off, press and hold down
the 'Front LED' and 'Feedback Elim' buttons. Keep holding them down and power up the ShowBox. After two seconds,
release the buttons and the ShowBox settings are back to their factory default.
If you do a factory default reset, you are also wiping the ShowBox's memory of previously paired devices.
To remedy this, on your phone, tablet or other Bluetooth device, you will need to 'forget device' in the Bluetooth
settings, then re-pair in order to regain communication and functionality.
This single-colored LED indicates the charging status of the ShowBox battery.
When the ShowBox is plugged into a live power outlet and the battery is charging,
this LED will illuminate and slow flash green. When the battery is fully charged,
This is a permanent reset with no undo.
15
Advertisement
Table of Contents
