Safety Functions On Lp-Rv Series - Panasonic LP-RV Series Safety Manual

Safety Functions on LP-RV series

This product has the functions shown below for safety measures.
Use these functions properly and operate the laser system safely.
Key Switch
The main power of this product is the key switch located on the controller unit.
Only when the key switch is turned OFF (in O position), the key can be pulled out.
When the laser marker is not in use, the key should be in safekeeping by a laser safety manager.
Internal Shutter
By closing the shutter located inside the head unit, the laser beam is shut off.
Manual Reset for the Alarm
If the interlock input or other input signal for safety devices is opened, or in the event of the product failure, the laser marker
becomes in alarm status and operates as follows;
• The internal shutter is closed and laser pumping is turned to off.
• ALARM OUT (Y15) is turned to off.
• The controller beeps out for the error notification.
• The display panel on the controller shows the error code.
• The error dialog appears on the screen of the PC setting software Laser Marker NAVI smart.
When an alarm generates, reset the system status by one of the following methods, after release the cause of the error.
• Turn off the key switch once and power it on again.
• Click on the "confirm" button on the error dialog of Laser Marker NAVI smart software.
• Turn on ALARM RESET IN (X15) in I/O terminal.
• Transmit the communication command for the alarm reset (ARS command).
OFF
ON
Key Switch
MJEC-LPRV-SAFETY-4
Controller
25