Troubleshooting - Grundig SIS 9180 User Manual

5 Troubleshooting

Problem
The base does not heat (16) al-
though the appliance is plugged.
The appliance does not produce
steam.
Water drips onto the fabric.
Sediments and residues fall of
from the base (16) while ironing.
There are stains on the base (16). Wet clothes are ironed / scale
The on/off button (6) of the appli-
ance blinks.
Calc cleaning button
blinking.
Icons on the LED display (1) are
not clear.
46 / EN
Possible cause
There may be a problem with
the connection.
Press the on/off button (6).
The amount of water in the
water tank (11) may be insuf-
ficient.
Check if the water reservoir
(11) is installed in its housing.
Water may come out when
you press the steam trig-
ger (4) before the appliance
reaches the set temperature.
Such sediments may occur if
the water you use in your ap-
pliance is too calcareous.
stains have occurred on the
base (16).
The appliance may have
switched to automatic power
off mode.
It is time for calc cleaning.
(5) is
The protecting film on the LED
display (1) may be still on.
Solution
Check the plug and the power
cord of the appliance
Contact the authorized service if
the appliance does not operate
although the appliance is plugged
and you have pressed the on/off
(6) button.
Fill water into the water tank up to
the MAX line (see 3.4).
The appliance does not provide
steam if the temperature is set to
"•" position. Adjust the temper-
ature setting as "Smart-Hygiene
mode, ••, ••• or MAX" (see 3.6).
The appliance is ready for iron-
ing the adjusted temperature is
shown on the LED display (1).
Fill the water reservoir of the ap-
pliance by mixing the tap water
and drinking water for your next
ironing operations.
Wipe the sediments and residues
with a lightly dampened cloth af-
ter the appliance is cooled down
adequately.
Press the on/off button (7)
(see 3.12).
Perform the calc cleaning opera-
tion (see 4.1).
Remove the protecting film on the
LED display (1).
Steam Generator / User Manual