Panasonic TH-P42ST50H Service Manual page 28

8.2.20. Remove the K-Board
1. Remove the screw (×1
2. Disconnect the connector (K1) and remove the K-Board
from the LED panel.
8.2.21. Remove the Cabinet assy from the
Plasma panel section
1. Place the Cabinet assy on a flat surface of a table
(covered by a soft cloth) and a cushion.
2. Remove the screws (×15
3. Remove the Cabinet assy from the Plasma panel section.
).
).
8.2.22. Remove the Contact metals
1. Remove the Tape from the Contact metals.
2. Remove the screws (×6
3. Remove the Contact metal side (L, R).
4. Remove the screws (×15
5. Remove the Contact metal bottom A.
8.2.23. Remove the C1-Board
1. Disconnect the flexible cables (CB1, CB2, CB3, CB4,
CB5, CB6 and CB7).
2. Disconnect the flexible cable (C11).
3. Disconnect the connectors (C10 and C14).
4. Remove the screws (×4
8.2.24. Remove the C2-Board
1. Disconnect the flexible cables (CB8, CB9, CB10, CB11,
CB12, CB13, CB14 and CB15).
2. Disconnect the flexible cable (C21).
3. Disconnect the connectors (C20 and C25).
4. Remove the screws (×4
28
).
).
) and remove the C1-Board.
) and remove the C2-Board.