Table of Contents
Advertisement
2.1
Assembling the monitor arm/base
To assemble the monitor base:
1.
Carefully place the monitor on the EPS foam, with the screen facing
down.
2.
Attach the base to the arm.
3.
Lift the screw ring and turn it clockwise to secure the base.
4.
Remove the stand cover.
5.
Place the arm hinge of the the stand assembly onto its compartment
on the rear of the monitor. Then use the L-shaped screwdriver to
secure it with four screws.
6.
Install the stand cover to the rear of the monitor.
Base screw size: M6 x 12 mm.
Hinge screw size: M4 x 10 mm.
2-1
Chapter 2: Setup
Advertisement
Table of Contents
