Table of Contents
Advertisement
Cleaning and Maintaining
Problem
The wireless remote
control does not operate.
The wired remote control
does not operate.
The air conditioner is
not turned on or off
immediately with the
wired remote control.
The Timed on/off
function does not
operate.
The indoor unit display
blinks continuously.
The air is not cool or
warm enough.
16 English
• Check whether the batteries are discharged. Replace the batteries with new ones.
• Make sure that nothing is blocking the remote control sensor.
• Check whether any strong lighting sources are near the air conditioner. Strong
light which comes from fluorescent bulbs or neon signs may interfere with the
remote control.
• Check whether the
remote control display. In this case, turn off both the air conditioner and the
auxiliary power switch, and then contact a service centre.
• Check whether the wired remote control is set for group control. In this
case, the air conditioners connected to the wired remote control are turned
on or off sequentially. This operation takes up to 32 seconds.
• Check whether you pressed the
after setting the on/off time. Set the on/off time.
• Turn on the air conditioner again by pressing the
• Turn off and then turn on the auxiliary power switch, and then turn on the
conditioner.
• If the indoor unit display is still blinking, contact a service centre.
• In the Cool mode, cool air does not come out if the set temperature is higher than
the current temperature.
– Remote control: Press the Temperature button repeatedly until the set
temperature (minimum: 18°C) is set to lower than the current temperature.
• In the Heat mode, warm air does not come out if the set temperature is lower
than the current temperature.
– Remote control: Press the Temperature button repeatedly until the set
temperature (maximum: 30°C) is set to higher than the current temperature.
• Both cooling and heating do not operate in the Fan mode. Select the Cool, Heat,
Auto, or Dry mode.
• Check whether the air filter is blocked with dirt. A dusty filter may decrease the
cooling and heating efficiencies. Clean the air filter frequently.
• If a cover is on the outdoor unit or any obstacle is present near the outdoor unit,
remove them.
• Install the outdoor unit in a well-ventilated place. Avoiding places exposed to
direct sunlight or close to a heating appliance.
• Place a sunscreen over the outdoor unit to protect it from direct sunlight.
• If the indoor unit is installed in a place exposed to direct sunlight, pull the curtains
on the windows.
Solution
indicator is displayed at the bottom right of the
(SET) button on the remote control
(Power) button.
Advertisement
Table of Contents
