Table of Contents
Advertisement
Condensation discharge at the front
Remove the small cover and introduce the vent hose
with the collar into the vent outlet. The tongue on the
collar should correspond with the slot on the vent hole.
Then push firmly to ensure secure fit.
If you use the front or side
vent outlet, the cover you
have removed should be
placed at the back.
Note
The cover on the front vent outlet will only fit the rear
vent outlet. The side vent outlet cover will ONLY fit the
rear vent outlet, it will NOT fit the front vent outlet.
The length of the vent
hose must not be more
than 4 m and it must not
contain
more
than two
bends when it is placed in
position for operation.
po0s3
You should NOT connect
the flexible vent hose to,
for example, a chimney or
flue
pipe
designed
to
carry the exhaust from a
fuel burning heating ap-
pliance.
The tumble dryer must be installed in a clean place,
where dirt does not build up.
Make sure there are no
obstructing
items
of
materials
near
the air-
intake louvres provided at
the back (e.g. paper, rag$
etc.).
Important
When operating the tumble dryer, the room temperature
must not exceed 35°C, as it may affect the performance
of the appliance.
To save energy, the room temperature should not be
lower than +15°C.
Level the tumble dryer
into place by screwing
unscrewing the front fe
as required.
Accurate
levelling will
keep
vibration
and
noise
to a minimum
when
the dryer is in
use.
:
Electrical connection
Before plugging the appliance into the wall socket, make
sure that:
!
1. the mains voltage corresponds to the voltage given ih
the technical specifications;
,
2. the meter, fuses, mains power supply and wall sock
can all take the maximum load required.
Make sure that the socket and plug are compatible
without having to use any type of adapter. If necessary,
have the domestic wiring system socket replaced.
Safety standards
require the appliance to be
earthed.
The Manufacturer accepts no liability for failure to
observe the above safety precautions.
CE
This appliance
complies
with the following
E.E.C. Directives:
!
= 73/23 EEC of 19.2.73 (Low Voltage Directive) and
subsequent modifications;
= 89/336 EEC of 3.5.89 (Electromagnetic Compatibi-
lity Directive) and subsequent modifications.
2p
Advertisement
Table of Contents
