Advertisement
4.4. Input tool option.
Adjust tool option refer to the BOM.
▪ Tool Option Input : PCBA Check Process
▪ Area Option Input : Set Assembly Process
*** Tool Option table
MODEL
55LM9600
Tool Option1
33001
Tool Option2
46421
Tool Option3
21325
Tool Option4
21039
Tool Option5
23063
Tool Option6
1321
Tool Option7
63019
After Input Tool Option and AC off
Before PCBA check, you have to change the Tool option and
have to AC off/on (Plug out and in)
(If missing this process, set can operate abnormally)
4.4.1. Profile
Must be changed the option value because being different with
some setting value depend on module maker, inch and market
4.4.2. Equipment
Adjustment remote control
4.4.3. Adjustment method
The input methods are same as other chassis.(Use ADJ Key
on the Adjust Remocon.)
(If not changed the option, the input menu can differ the model
spec.)
Refer to Job Expression of each main chassis ass'y
(EBTxxxxxxxx) for Option value
Caution : Don't Press "IN-STOP" key after completing the
function inspection.
Copyright ©
LG Electronics. Inc. All rights reserved.
Only for training and service purposes
47LM9600
47LM8600
72LM9500
32999
32983
33148
46421
42325
50517
21325
21357
21325
21039
12845
21039
23063
23063
6677
1321
1321
1321
63019
62763
63019
4.5. EDID D/L method
Recommend that don't connect HDMI and RGB(D-SUB) cable
when downloading the EDID.
If not possible, recommend that connect the MSPG equipment.
There are two methods of downloading the edid data
It is a VESA regulation. A PC or a MNT will display an optimal
resolution through information
Sharing without any necessity of user input. It is a realization
of "Plug and Play"
4.5.1. 1st Method
EDID datas are automatically downloaded when adjusting the
Tool Options.
Automatically downloaded when pushing the enter key after
adjusting the tool option5.
It takes about 2seconds
4.5.2. 2nd Method
● Caution : Must be checked that the tool option is right or not.
If tool option is wrong, hdmi edid data could not be
downloaded well.
1) Press the ADJ key
2) Move to the 10. EDID D/L and Press the right direction
key(►)
3) Press the right direction key(►) at Start.
4) After about a few seconds, appear "Waiting.." => "OK", then
compele.
4.5.3. RS-232C command Method
1) Command : AE 00 10
● Caution : Don't connect HDMI and RGB(D-SUB) cable when
downloading the EDID.
If the cables are connected, Downloading of edid
could be failed
- 11 -
LGE Internal Use Only
Advertisement
