Table of Contents
Advertisement
Playing Back Recordings
TV Playback or Viewing
Connect Camcorder to a TV to view
playback or recordings in progress.
C
TV with AUDIO/VIDEO IN Jacks.
Before you begin...
• Connect Camcorder to power source.
• Make all TV-Camcorder connections.
Set POWER to:
VCR
-* view playback.
CAMERA
-*■ view picture as it is
recorded.
Turn TV ON and set to LINE
INPUT.
See TV owner's manual.
To Audio In M To Video In
Audio/Video
1^1 , ^5
Cable
M wlnn
(Supplied)
Begin playback or recording.
To Audio/Video Out
TV without AUDIO/VIDEO IN Jacks.
To Audio/
Video Out
RF Adaptor
CH 3/4 Switch
VCR/TV
Selector
VHF Connecting
Cable
VHF Antenna
300 ohm-75 ohm
transformer
or F Connector
UHF Antenna
If TV has no VIDEO/AUDIO IN jacks, [
connect PV-RF16 RF Adaptor
(optional). Tune TV to CH 3 or 4 to
match RF Adaptor 3/4 switch. Set
Adaptor's TV/VCR switch to VCR for
playback.
To watch TV only,
turn TV on without AUDIO/VIDEO IN Jacks
connected (left).
a
Set Camcorder
POWER
to
OFF.
b
Set
RF
Adaptor
VCR/TV
Selector to
TV.
c
Turn
TV ON
and select channel.
Back of TV
To VHF Antenna
Terminal
CATV System Installer
This reminder is provided to call the
CATV system installer's attention to
Article 820-40 of the NEC in USA (and
to the Canadian Electrical Code in
Canada) that provides guidelines for
proper grounding and, in particular,
specifies that the cable ground shall be
connected to the grounding system of
the building, as close to the point of
cable entry as practical.
Advertisement
Table of Contents
