X10 AK10A Owner's Manual page 5

R
ECEIVER
2.4 GHz
Antenna
L EFT
AUDIO O UT
2.4 GHz Channel
Audio Out
Switch
Jacks
(on bottom)
8
AK10A -01/00
ON-OFF
RIGHT
Switch
(on side)
DC 12V
Power Supply
Jack
C
ONNECTING
H A
OOKING UP THE UDIO
1. Connect the jack on the audio cable (supplied) to the audio out
jack on your PC's sound card (or other audio source).
2. Connect the red RCA plug to the socket labelled AUDIO RIGHT
and the white RCA plug to the jack labeled AUDIO LEFT on the
Audio Sender.
3. Plug the Audio Sender's Power Supply (the smaller of the two
power supplies) into a convenient 120 volt wall outlet and plug its
jack into the Audio Sender.
4. Position the Audio Sender in a convenient location such as on top
of the computer monitor and orient the antenna so that the flat
side points in the direction of the room where you will be
installing the Audio Receiver.
P
AUDIO IN
AUDIO OUT
U
P
S
ENDER
CO M PUTE R
MO NITOR
P C
9
AK10A-01/00