Electrolux EEA17200L User Manual page 44

44 www.electrolux.com
Problem and alarm code
The programme does not start.
The appliance does not fill with wa‐
ter.
• The indicator
intermittently.
• Acoustic signal sounds 1 time in‐
termittently.
The appliance does not drain the
water.
• The indicator
intermittently.
• Acoustic signal sounds 2 times
intermittently.
The anti-flood device is on.
• The indicator
intermittently.
• Acoustic signal sounds 3 times
intermittently.
Malfunction of the water level detec‐
tion sensor.
• The indicator
intermittently.
• Acoustic signal sounds 4 times
intermittently.
Malfunction of the wash pump or
the drain pump.
• The indicator
intermittently.
• Acoustic signal sounds 5 times
intermittently.
The temperature of the water inside
the appliance is too high or malfunc‐
tion of the temperature sensor oc‐
curred.
• The indicator
intermittently.
• Acoustic signal sounds 6 times
intermittently.
Possible cause and solution
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or
wait for the end of the countdown.
• The appliance recharges the resin inside
the water softener. The duration of the pro‐
cedure is approximately 5 minutes.
• Make sure that the water tap is open.
• Make sure that the pressure of the water
supply is not too low. For this information,
flashes 1 time
contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is
not clogged.
• Make sure that the inlet hose has no kinks
or bends.
• Make sure that the sink spigot is not clog‐
ged.
• Make sure that the interior filter system is
flashes 2 times
not clogged.
• Make sure that the drain hose has no kinks
or bends.
• Close the water tap.
• Make sure that the appliance is correctly in‐
flashes 3 times
stalled.
• Make sure the baskets are loaded as in‐
structed in the user manual.
• Make sure that the filters are clean.
• Switch the appliance off and on.
flashes 4 times
• Switch the appliance off and on.
flashes 5 times
• Make sure that the temperature of the inlet
water does not exceed 60°C.
• Switch the appliance off and on.
flashes 6 times