Table of Contents
Advertisement
Warning and Safety instructions
The machine must be isolated from the electricity supply when
cleaning and maintaining the machine and in the event of a fault.
The machine must only be connected to the on-site water supply
using a new hose kit. Old hose kits must not be re-used. Check the
condition of the hoses regularly so that you can replace them in good
time and avoid the risk of any water damage.
The water flow pressure must be at least 100 kPa and should not
exceed 1000 kPa.
In areas which may be subject to infestation by cockroaches or
other vermin, pay particular attention to keeping the machine and its
surroundings in a clean condition at all times. Any damage which may
be caused by cockroaches or other vermin will not be covered by the
warranty.
The machine must not be used in a non-stationary location (e.g. on
a ship).
Do not make any alterations to the machine, unless authorised to
do so by Miele.
Correct use
Do not install the washing machine in a room where there is a risk
of frost. Frozen hoses may burst or split. The reliability of the elec-
tronic control unit may be impaired at temperatures below freezing
point.
Before using the machine for the first time, check that the transit
bars at the rear of the machine have been removed (see "Installation
- Removing the transit bars"). During spinning, a transit bar which is
still in place may result in damage to both the machine and adjacent
furniture or appliances.
10
Advertisement
Table of Contents
