Smeg LVS262EB User Manual page 13

• The remaining indicators are off.
• The display shows the current setting:
e.g. = level 5.
2. Press Program repeatedly to change the
setting.
3. Press the on/off button to confirm the
setting.
8.3 The rinse aid empty notification
The rinse aid helps to dry the dishes without
streaks and stains. It is automatically
released during the final rinse.
When the rinse aid chamber is empty, the
rinse aid indicator turns on. If the drying
results are satisfactory while using multi-
tablets only, you can deactivate the
notification for refilling the rinse aid. However,
for best drying performance, always use rinse
aid.
If standard detergent or multi-tablets without
rinse aid are used, activate the notification to
keep the rinse aid refill indicator active.
How to deactivate the rinse aid
empty notification
Make sure the appliance is in user mode.
1. Press Start.
• The indicator
• The remaining indicators are off.
• The display shows the current setting.
– = the rinse aid empty
notification is deactivated.
– = the rinse aid empty
notification is activated.
2. Press Start to change the setting.
3. Press the on/off button to confirm the
setting.
8.4 Dry Assist
Dry Assist improves the drying results with
less energy consumption. The appliance door
opens automatically during the drying phase
and remains ajar.
still flashes.
Dry Assist is automatically activated with all
programmes other than
The duration of the drying phase and the door
opening time vary depending on the selected
programme and options.
When Dry Assist opens the door, the display
shows the remaining time of the running
programme.
CAUTION!
Do not try to close the appliance door
within 2 minutes after automatic opening.
This can cause damage to the appliance.
If, afterwards, the door is closed for at
least 3 minutes, the running programme
ends.
CAUTION!
If children have access to the appliance,
we advise to deactivate Dry Assist. The
automatic opening of the door may pose
a danger.
How to deactivate Dry Assist
Make sure the appliance is in user mode.
1. Press Delay.
• The indicator
• The remaining indicators are off.
• The display shows the current setting:
– = Dry Assist is deactivated.
– = Dry Assist is activated.
2. Press Delay to change the setting.
3. Press the on/off button to confirm the
setting.
(if applicable).
still flashes.
ENGLISH 13