Husqvarna Z572X Operator's Manual page 13

Note:
Do not make adjustments to the seat when
the product is in operation.
• Do the steps that follow to move the seat forward
or rearward.
a) Pull up the lever (A) on the right side of the
seat and hold it.
A
b) Move the seat to the correct position and
release the lever.
• Turn the knob (B) on the front of the seat
clockwise or counterclockwise to make the seat
suspension hard or soft.
To fold the seat
The seat can be folded forward to get access to the
battery and hydrostatic gears.
1. Park the product on level ground.
2. Push down the latch (A) behind the seat to
release the seat.
3. Fold the seat forward until the rod (B) is
engaged.
To engage and disengage the
parking brake
This product has no dedicated parking brake lever.
The parking brake is integrated in the 2 control
levers.
2171 - 001 - 14.06.2023
B
B
A
• Push the 2 control levers away from the seat
at the same time to engage the parking brake.
Product overview on page 4 for the
Refer to
location of the control levers.
Note:
The product must be stationary when
you engage the parking brake.
Note:
The engine will stop if you do not push
the 2 control levers away from the seat at the
same time.
• Pull the 2 control levers in the direction of the
seat to disengage the parking brake.
To disengage and engage the drive
system
CAUTION:
drive system when the product is parked
on level ground.
If it is necessary to move the product by hand, with
the engine off, the drive system must be disengaged.
The drive system is disengaged and engaged by the
2 bypass valves. The bypass valves are found on
the inner sides of the transaxles.
Follow the procedure below to disengage the drive
system.
1. Park the product on level ground and stop the
engine.
2. Set the cutting deck to the lowest position.
3. Turn the bypass valves 45° clockwise to the
BYPASS position.
4. To engage the drive system, turn the bypass
valves to the RUN position.
To set the cutting deck in transport
position or mow position
The cutting deck must be in transport position during
transportation.
Only disengage the
13