Hp-Ib Universal Commands; Dcl Sdc; Get - HP 8112A Operating, Programming And Servicing Manual

HP-I B Universal
Commands
Note
6-18 Programming
The HP 8112A supports the following HP-IB Universal commands:
These are HP-IB commands, NOT instrument programming
commands. They are not used in programming messages. If you
require more information on the HP-IB protocol and hardware refer
to "General" for a list of references.
HP-IB
Mnemonic
DCL
SDC
GTL

GET

UNL
UNT
SPE
SPD
MLA
MTA
DCL An HP-IB DCL command causes the HP 8112A to load its standard
parameter set. The instrument remains in its current mode (local or
remote).
An HP-IB SDC command causes the HP 8112A to load its standard
parameter set and enter remote mode.
G E T An HP-IB GET command simulates an external trigger to the HP
8112A in TRIG, E.BUR and E.SWP modes.
Description
Device Clear
Selected Device Clear
Local Lockout
Go to Local
Group Execute Trigger
Unlisten
Untalk
Serial Poll Enable
Serial Poll Disable
My listen address
My talk address
BASIC S&/5.1 equivalent
CLEAR 7
CLEAR 712
LOCAL LOCKOUT 7
LOCAL 712 / LOCAL 7
TRIGGER 712 / TRIGGER 7
SEND 712;UNL
SEND 712;UNT
SPOLL(712)
selectable
selectable