Setting The Lnb Type; Setting The Lnb Band(S); Changing The "Variable" Setting; Saving Your Settings - Pace MSS100 Series Service Manual

Setting the LNB type
The LNB option must be set to correspond with the type
of LNB on your dish.
>) Press < or» to set the required value (see table
right).
If Multi Band or Universal is selected, the next option in
the menu ("LNB Band") changes to become two options,
Low Band and High Band.
You must then set the "LNB Band" or "Low Band" and
"High Band" options to correspond with the LNB (see
below).
Setting Usage
Single If the LNB is single-band.
Universal If the dish has a universal LNB. This is
a specific type of multi-band tone-
switching LNB with specific band
settings (see table below) anda
voltage-switching polariser.
Multi Band Tone If the LNB is multi-band and uses a
tone to switch between bands.
Notes
if "Multi Band Tone" or "Universal" is set then the
"Tone" option disappears from the Set Up
Programme Menu.
If "Multi Band Tone", "Multi Band Volt" or "Univer-
sal" is selected ,then a "Band" option appears in the
Set Up Programme Menu.
Multi Band Volt If the LNB is multi-band and uses
voltage to switch between bands.
Setting the LNB Band(s)
>> For a single-band LNB, press < or » to select one of
the LNB bands shown right or choose the setting
"Variable" (see below).
The numbers in the LNB Band names are the frequencies
(in GHz) of the LNB's local oscillator. The second column
shows the frequency range over which you should tune
at the Set Up Programme Menu. We do not recommend
that you tune outside these ranges, as performance
cannot then be guaranteed.
>> For a multi-band LNB, select the Low Band and High LNB Band Freq. Range(GHz) Typical Satellites
Band options in turn and press 4 or ® to set the FSS A 9.750 10.700- 11.800 Astra 1A, 1B, 1C, 1D/
correct value for each band. The following options Intelsat/ Eutelsat
arerevallable: FSSB 10.000 10.920-11.700 Astra 1A, 1B, 10
Intelsat/ Eutelsat
Low Band FSS A 9.750/ FSS B 10.000/ DBS 10.750 11.700- 12.500 TDF/ TV-Sav/
C-Band 5.150 Hispasat
High Band md Meisohin 11.475) T-COM 11.475 12.500- 12.750 Telecom 24, 2B, 1C
a d e eee C-Band 5.150 3.700- 4.200 —Asiasat
BSS 10.600 11.700- 12.500 Astra
Note
If the LNB option is set to Universal, you cannot
change the Low Band and High Band settings.
Changing the "Variable" setting
>> Select "Var." (the number next to it flashes). Use the
number keys to key in the LNB's local oscillator
frequency (in the range 9.050 to 13.000 GHz).
Saving your settings
You do not need to press STORE after changing each
setting. Instead make all the changes you desire at the
menu, then press STORE to save all the settings.
Installation