The Radio: Manual Tuning.22 - Panasonic SC-DT300 Operating Instructions Manual

The radio: manual tuning
PWRCl)/J VOLUME, DOWN, UP
1
»- ——
SELECT
TUNER/
BAND
VOLUME
Radio stations can be tuned manually by selecting the station's
frequency or they can be preset into channels to make it easy to tune
(■• page 23).
1 Press [SYSTEM^] to turn on the unit.
2
Press [TUNER/BAND] to select "FM"
or "AM".
Each time you press the button:
FM<—>AM
3
Press [K^/v] or [a/►>!] to select the
frequency of the required station.
Displayed when a radio station is tuned.
Press and hold [f«/v] or [a/^W] until the frequency starts
scrolling to start automatic tuning. Tuning stops when a sta¬
tion is found.
4
Adjust the volume.
If noise is excessive in FM
Press [SHIFT]+[FM MODE] to display "MONO".
TUNED
MONO
FM 87.9
This mode improves sound quality if reception is weak but broad¬
casts are heard in monaural.
Press {SHIFT]+[FM MODE] again to cancel the mode.
The mode is also canceled when you changed the frequency.
Turn "MONO" off for normal listening.
Stereo and monaural broadcasts are automatically played as they
are received.
FM frequency step
Main unit only
The step is factory-set to 0.2 MHz, but you can change it to receive
broadcasts allocated 0.1-MHz steps.
0 Press [SELECT] to select "FM".
(§) Press and hold [SELECT],
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
Any FM frequencies preset in channels will be changed by this
procedure. Preset them again.
RQT6534