Troubleshooting - Electrolux KODGS20TX User Manual

9. After cleaning, install the glass panel and
the oven door.
If the door is installed correctly, you will hear
a click when closing the latches.
The screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame on the screen-printing zones is not
rough when you touch it.
When installed correctly, the door trim clicks.
Make sure that you install the internal glass
panel in the seats correctly.
12.6 Replacing the lamp
WARNING!
Risk of electric shock.
The lamp can be hot.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 What to do if...
In any cases not included in this table please
contact an Authorised Service Centre.
Problem
The appliance does not
heat up.
The door gasket is dam‐
aged.
The display shows
"12.00".
16 ENGLISH
A
Cause and remedy
The fuse is blown. Make
sure that the fuse is the
cause of the malfunction.
If the problem persists,
contact a qualified electri‐
cian.
Do not use the appliance.
Contact an Authorised
Service Centre.
There was a power cut.
Set the time of day.
1. Turn off the appliance and wait until it is
cold.
2. Disconnect the appliance from the mains.
3. Place the cloth on the oven floor.
CAUTION!
Always hold the halogen lamp with a
cloth to prevent grease residue from
burning on the lamp.
Back lamp
1. Turn the glass cover to remove it.
2. Clean the glass cover.
3. Replace the lamp with a suitable 300 °C
heat-resistant lamp.
4. Install the glass cover.
Problem
The water leaks out of the
cavity embossment.
Unsatisfying cooking per‐
formance of the function:
True Fan Cooking PLUS .
The lamp does not work.
Cause and remedy
There is too much water
in the cavity emboss‐
ment. Deactivate the ap‐
pliance and make sure it
is cold. Wipe the water
with a cloth or a sponge.
Add the correct amount of
water. Refer to "Daily
use", Setting the function:
True Fan Cooking PLUS.
The cavity embossment
is not filled with water.
Add the correct amount of
water. Refer to "Daily
use", Setting the function:
True Fan Cooking PLUS.
The lamp is burnt out.
Replace the lamp. Refer
to "Care and cleaning",
Replacing the lamp.