Kohler 7CCO Operation And Installation Manual page 9

Notes
NOTICE
This generator set has been rewired from its
nameplate voltage to:
NOTICE
This is a positive terminal only.
Do not attach negative lead!
Affix notice to generator set after reconnecting to a
voltage different than the nameplate. Order voltage
reconnection decal 246242 from authorized service
distributors/dealers.
Wipe up all spilled diesel fuel after bleeding system.
Wash hands after any contact with fuel oil.
Pay special attention to the coolant level. After the
coolant has been drained, some time is required before
complete refill of the engine water jacket takes place.
Engine Damage! Failure to bleed air from cooling
system may cause overheating and subsequent
damage to engine.
Do not turn on block heater before filling cooling system.
Run engine until warm and refill radiator to purge air
from the system before energizing block heater. Block
heater failure occurs if heater element is not immersed
in water.
TP-5594 5/95
246242
NOTE
NOTE
NOTE
NOTE
NOTE
Hardware Damage! Engine and generator set may
use both American Standard and metric hardware. Use
the correct size tools to prevent rounding of bolt heads
and nuts.
When replacing hardware, do not substitute with
inferior grade hardware.
available in different hardness ratings.
Standard hardware uses a series of markings and
metric hardware uses a numeric system to indicate
hardness. Check markings on bolt head and nuts for
identification.
For standby service connect output of generator set to a
suitably rated transfer switch in accordance with
Canadian Electrical Code, Part 1.
This generator set does not comply with United
States Coast Guard (U.S.C.G.) requirements and
must not be used for marine applications. Use only
generator sets specified for marine use in marine
installations. U.S.C.G. Regulation 33CFR183 requires
a generator set to be ignition protected when used in a
gasoline-fueled environment.
Do not tee into fuel injected fuel systems. Use a two dip
tube arrangement for fuel supply. Consult an authorized
service dealer for further fuel system installation
information.
Safety Precautions and Instructions VII
NOTE
NOTE
Screws and nuts are
American
NOTE
NOTE
NOTE