Onkyo TX-8511 Instruction Manual page 9

Making system connections
USA and Canadian models
"!
SPEAKERIMPEDANCESELECTOR
AORB: _ AORB:
g OHMS MIN.PSPIEAKER 4 OHMS MINJ_PEAKER
A+B
8 OHMS MINJSpEAKER
Other models
CAUTION: SPEAKER IMPEDANCE
A or B : 4 ohms rain/speaKer
A + B 8 ohms flqllq./sD_aKer
USA and Canadian models:
According to the impedance of the _peakers
used. set the SPEAKER INPEDANCE
SELECTOR on the rear panel as shown m
the table
Usable speaker impedance
A or B spea_er
4 ohms - {_ohms/speaker
A and B _peakers
8 ohms or above _peaKer
Selector
position
A or B speaker
8 ohm_ or aNdre/speaker
• Do not plug m the power eora dunrlg
_peaKer _y_lem col_necttflll and opera-
tion of the SPEAKER IMPEDANCE
SELECTOR.
Other models:
• q_le load mlpeaance of each sl_aker
system connected to this unit ll/osl be at
least 4 ohms. ill u_ing onl) A or only B,
4 ohms rain.: ifA a_d B, 8 ohm_ min._
2 3
SPEAKER A SPEAKER A
SPEAKER B SPEAKER B L
R /
%
L_.J
NO
Note:
TOprevent _3amage to circuitry, never short-circuit the positive (+
and negative (-) speaker wires.
l, Open the lever.
2 Twist rare ends very tight, and insert
tile _,_/rc.
3 Close thelever
Before making an? connecuons, please refer
m the explanation of"Speaker impedance".
You C_II collnecl _WO he_alrate
pairs of
speaker _ysteme
Please conllecl _ach speaker accorth/l_ ]o
the illustration, observing me correct _2(iii-
nections
for R, L ÷ tmu
• DI IlOl LIq_' klnl/l?Cehgllrily
hmp
nr
extremely thin speaker lead£ II the DC
resistance of the speaker leads is too
high, the damping lactor wall decrease,
adversely arrecnng the sound quaht_
• When using unl} one speaker ur _hen
you _ish ta listen to m_maurai "nnn_ r.
the single streaker shlttlhl lleVer be con-
netted iI parallel tu D(Illl the right aria
left channel wrminals at the same time.
o
t_ c_
9