Table of Contents
Advertisement
Fault
The spin result is not
satisfactory. The laun-
dry is too wet/too
damp.
Detergent residue on
the damp washing.
Detergent residue on
the dry laundry.
Drying programme
does not start.
The programme dura-
tion changes during
the wash cycle.
Drum jerks after the
programme starts.
Detergent or fabric
softener drips off the
seal and collects on
the door or in the seal
fold.
Cause and troubleshooting
Start the Centrif.(Spin) programme.
▶
Unbalance load detection system is using a reduced
spin speed to eliminate an unbalance.
Redistribute the laundry in the drum.
▶
Note: Where possible, mix large and small items in
the drum. Different sized items of laundry distribute
themselves better during the spin cycle.
Start the Centrif.(Spin) programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Start the Sköljning(Rinse) programme.
▶
Detergents may contain water-insoluble substances
that deposit on the laundry.
Brush out the laundry after washing and drying.
▶
Door is not closed.
Close the door.
▶
No drying programme is selected.
Select a suitable drying programme.
▶
→ "Programmes", Page 26
The programme operation is optimised electronically.
This may change the programme duration.
Not a fault – no action required.
▶
The unbalanced load detection system eliminates an
imbalance by repeatedly redistributing the laundry.
Not a fault – no action required.
▶
Note: When loading, where possible, place large and
small items of laundry together in the drum. Different
sized items of laundry distribute themselves better
during the spin cycle.
Foam detection system switches on a rinse cycle if
foam build-up is too high.
Not a fault – no action required.
▶
This is caused by an internal motor test.
Not a fault – no action required.
▶
Too much detergent/fabric softener in the detergent
drawer.
When dosing liquid detergent and fabric softener,
▶
observe the marking in the detergent drawer and
do not dose above this.
Troubleshooting en
47
Advertisement
Table of Contents
