Table of Contents
Advertisement
Chapter 02
Preparations
Installation
Attaching the Stand
― Disassembly is the reverse order of assembly.
S27AG50* / S32AG50* / S27AG52* / S32AG52*
3
2
Tightly fasten the connecting screw at
Push the assembled stand into the main body in the direction of the arrow as
the bottom of the stand base. Fasten
shown in the figure.
the large screw in the middle for
assembly.
6
Rotate the COVER-REAR TOP clockwise.
4
Disassemble the COVER-REAR TOP.
7
8
Stand up the monitor as shown in the
After installing the stand, place the
figure.
product upright.
1
Put the stand base onto the stand neck as the
direction shown in the figure. Check that the stand
neck is firmly connected.
5
Assemble the COVER-REAR TOP to the stand neck
as shown in the figure.
Caution
Do not arbitrarily remove the panel film. If not
observed, the warranty service may be restricted.
9
Advertisement
Table of Contents
