Advertisement
● OPERATING INSTRUCTIONS ●
E
CONO COOL OPERATION
Press
during COOL mode
ECONO COOL operation.
The unit performs swing operation vertically in various cycle according to the
temperature of the unit. Set temperature is set 2°C higher automatically.
Press
again to cancel ECONO COOL operation.
• ECONO COOL operation also is canceled when the VANE button is
pressed.
What is "ECONO COOL"?
Swing air fl ow (change of air fl ow) makes you feel cooler than constant air fl ow.
So, even though the set temperature is automatically set 2°C higher, it is pos-
sible to perform cooling operation with keeping comfort. As a result, energy can
be saved.
T
IMER OPERATION (ON/OFF TIMER)
1
Press
or
during operation to set the timer.
(ON timer) : The unit turns ON at the set
time.
(OFF timer) : The unit turns OFF at the set
time.
*
or
blinks.
* Make sure that the current time is set correctly.
2
Press
(Increase) and
time of timer.
Each press increases or decreases the set time by 10 minutes.
• Set the timer while
or
3
Press
or
again to cancel timer.
Note:
• ON and OFF timers can be set together.
operations.
• If power failure occurs while ON/OFF timer is set, see
function".
En-7
page 5
to start
Page 3
(Decrease) to set the
is blinking.
mark indicates the order of timer
page 5
"Auto restart
www.ttair.co.th | Tel : 02-385-0728 | E-mail : sales@ttair.co.th | LINE ID : @ttair
D
.S.PLASMA OPERATION
Press
to start D.S.PLASMA operation.
• PLASMA lamp turns on. (Display section)
Press
again to cancel D.S.PLASMA operation.
What is "D.S.PLASMA operation"?
D.S.Plasma operation consists of deodorizing and air purifying features.
Particles of odor-releasing substances are absorbed and decomposed by the
plasma deodorizing fi lter. Particles of allergens such as pollens and house dust
are collected by the plasma anti-allergy fi lter. These fi lters work with negative
ions generated by the plasma electrode unit.
C
LEAN OPERATION
Press
to activate CLEAN operation.
• The unit performs CLEAN operation when it is stopped with the
button or OFF timer after COOL/DRY operation. CLEAN lamp turns
on. (Display section)
• CLEAN operation is not performed when: COOL is operated less than
3 minutes/ DRY is operated less than 6 minutes.
Press
again to deactivate CLEAN operation.
• Pressing
does not deactivate CLEAN operation.
What is "CLEAN operation"?
CLEAN operation function helps to keep the unit clean and prevents mold growth
by generating small amount of ozone (
40 minutes. It is recommended to keep CLEAN operation active at all times.
About 0.01 ppm at the air outlet. This is the same level found in nature, such
*1
as in forests, and there is no effect on the human body.
Note:
• Fan is stopped for the fi rst 15 minutes of CLEAN operation.
• Do not turn OFF the breaker during CLEAN operation.
) and performing FAN operation for about
*1
Advertisement
