Silencing The Beeper - Canon EOS REBEL 2000 Manual

©з Auto Exposure Bracketing (AEB)
-2,1,%,1,2* Take the pictures.
+ Correct exposure * The viewfinder and LCD panel will
display the respective exposure level for
РИ?" 7 Underexposure each bracketed shot.
* During AEB shooting while the exposure
724 : Overexposure level is displayed, the arrow pointing to
the AEB icon on the LCD panel will blink
along with the exposure level index.
* AEB is not canceled automatically. To cancel AEB, set the bracketing amount to 0.0.
С «If the self-timer is used, the three AEB shots will be taken in continuous succession
automatically.
* If the Command Dial is set to a Basic Zone mode, AEB will be canceled automatically.
* If flash is used, AEB cannot be executed.
bracketed shots continuously. However, the respective exposure level will not be displayed.
= AEB can be used in combination with exposure -2
'compensation. If the bracketing range exceeds
the displayable range, the display will be as
shown on the right (with a sample AEB amount
of +1 stop).
Б + In the continuous shooting mode, holding down the shutter button will take all three
1* AEB amountcl 1 stn,
1 sap AEB in Hat eere compen
41 sp AEB in 4 Sop geez corps
3 1 Sop AEB ath Заир pose прека.
E
#1) Silencing the Beeper =
The beeper can be silenced in all of the picture- taking modes.
Press the Function button so that the
<» > arrow points to the <"1)> icon.
* The frame counter on the LCD panel
will display "1."
Turn the < з > dial so that the LCD
panel displays "0."
* To enable the beeper again, turn the
< £^» dial so that "1" is displayed.
* The setting takes effect after any of
the following actions:
- The shutter button is pressed halfway.
+ The Command Dial is turned.
+ Six seconds elapse.
54