Installation - LG GR-486 Series Owner's Manual

INSTALLATION

1. Select a good location.
Place your refrigerator where it is easy to use.
2. Avoid placing the unit near heat sources,
direct sunlight or moisture.
3. To avoid vibrations, the unit must be level.
If required, adjust the leveling screws to
compensate for unevenness of the floor.
The front should be slightly higher than the
rear to aid in door closing.
Leveling screws can be turned easily by
tipping the cabinet slightly.
Turn the leveling screws clockwise (
raise the unit, counterclockwise (
it.
4. Don't install this appliance below 5 °. It may
cause the debasement of the refrigerator.
NEXT
1. Clean your refrigerator thoroughly and wipe off
all dust accumulated during shipping.
2. Install accessories such as ice cube box, etc.,
in their proper places. They are packed
together to prevent possible damage during
shipment.
3. Connect the power supply cord (or plug) to the
outlet. Don't double up with other appliances
on the same outlet.
4. Prior to storing food, leave your refrigerator on
for 2 or 3 hours.
Check the flow of cold air in the freezer
compartment to ensure proper cooling. Your
refrigerator is now ready for use.
5. After installing the appliance, connect the
power plug into a socket outlet. Before moving
and discarding the appliance, disconnect the
plug from the socket outlet.
Inverter-On feature (Optional)
Minimum requirement: UPS/ Inverter should be in ON condition having minimum 600VA capacity
along with minimum 120Ah capacity battery connected with the refrigerator's power supply socket.
Dimensions and Clearances
Too small of a distance from adjacent items may
result in degradation of freezing capability and
increased electricity costs. Allow over 50mm
clearance from each adjacent wall when
installing the appliance.
) to
) to lower
-
A
B
C
D
E
F
G
H
Ambient Temperature
The appliance is designed to operate within a
limited range of ambient temperatures,
depending on the climate zone. do not use the
appliance at a temperature exceeding the limit.
The internal temperatures could be affected by
the location of the appliance, the ambient
temperature, the frequency of door opening and
so on.
The climate class can be found on the rating
label.
Climate Class
SN (Extended Temperate)
N (Temperate)
ST (Subtropical)
T (Tropical)
*Australia, India, Kenya
NOTE
The appliances rated from SN to T are intended
to be used at an ambient temperature between
0
10C and 43C
11
Image for representation purpose only
Size
Type(a)
700 mm
1780 mm
730 mm
25 mm
660 mm
705 mm
1331 mm
1232 mm
Ambient Temperature Range C
+10 - +32
+16 - +32
+16 - +38
+16 - +43/+10 - +43*
0
Type(b)
700 mm
1680 mm
730 mm
25 mm
660 mm
705 mm
1331 mm
1232 mm
0