Checking The Digital-Signal Strength =Digital; Using The R.surf Feature; Selecting A Menu Language - Samsung TX-T2781 Owner's Instructions Manual

Checking the Digital-Signal Strength =Digital
Unlike analog channels, which can vary in reception quality from "snowy" to clear,
digital(HDTV) channels have either perfect reception quality or you will not receive them at
all. So, unlike analog channels, you cannot fine tune a digital channel. You can, however,
adjust your antenna to improve the reception of available digital channels.
1 Press the MENU button to display the menu.
Press the A or _' button to select Channel, then press the ENTER button.
Press the A or 'V button to select Signal Strength, then press the ENTER button.
If the signal strength meter indicates that the signal is weak, physically adjust your antenna
to increase the signal strength. Continue to adjust the antenna until you find the best position
with the strongest signal.
Press the EXIT button to exit.
You can also press the ENTER button to select OK, then press the EXIT button to exit.
Using the R.Surf Feature
This feature allows you to set the TV to return to a particular channel after a certain amount
of time. For example, you may be watching a channel when commercials start. You can set
the R.Surf to "5 minutes", then switch channels. After 5 minutes, the TV will return to the
original channel. To use the R.Surf feature:
1 While you are watching the channel to which you want to return, press the R.SURF button.
The Surf Off is displayed.
2 Press the R.SURF button again to set the timer in thirty second intervals, up to five minutes.
The time will start decreasing while you are setting up the timer, and wilt reset after
5 minutes has passed or you turn it off.
3 The time you set wilt begin counting down on the screen.
When the time runs out, the TV will return to the channel you were watching when you set the
timer.
Selecting a Menu Language
1 Press the MENU button to display the menu.
Press the A or T button to select Setup, then press the ENTER button.
2 Press the A or _' button to select Language, then press the ENTER button.
3 Press the A or _' button to select the appropriate language: English, Espa_ol or Fran£ais,
then press the ENTER button.
Press the EXIT button to exit.
_ Language
# Move C'_ Enter rrT; Return