Control Operation; Power Switch; Level Controls 1 And 2; Bridge Switch - Crown Pulse 21100 User Manual

5 . 0
a. Power Switch
Pressing this switch so that the
white dot is closest to the front
panel signals to the
microprocessor that the user
wishes to turn on the power
supply. Note that the
microprocessor will only switch
the power supply on once it has
assured that there are no
internal faults. From the first
application of AC power it
takes approximately 7 seconds
to complete these tests. During
the test time the microprocessor will flash both the TEMP lights and the FAULT light once a second. If the
amplifier has already completed these tests, then when the switch is pressed, power up will occur within 1
second. While the power up sequence is being completed all amplifiers channels are muted.
b. Level controls 1 and 2
These controls allow the user to change the sensitivity, or the level required to drive each channel of the
amplifier into clip, from approximately +90dBu with the controls fully counter clockwise, to +1dBu with the
controls full clockwise. +1dBu equals approximately 870mV RMS and this level will be just sufficient with a 4
Ohm load and nominal AC voltage to drive the amplifier into clip. If the amplifier is operated in bridge mode,
use the channel 1 level control only, the channel 2 control has no effect.
Supplied with each PULSE amplifier are special blanking plugs that may be fitted after the control knobs have
been pulled off thus allowing the levels to be set and then made tamper proof.
c. Bridge switch
Located on the rear panel, this switch enables bridge mode operation.
Activation of this switch is indicated by the Bridge indicator on the front
panel.
When the amplifier is operated in bridge mode, the power available doubles
allowing larger speakers to be driven. Two things must be kept in mind
when bridge mode is used, namely the minimum impedance that can be
driven increases from 2 ohms to 4 ohms and if binding post outputs are
used, the speaker wiring must be changed as described in the Audio
Connections section of this manual.
9
C o n t r o l o p e r a t i o n