Table of Contents
Advertisement
CAL Eye Control Calibration
48
Hold the camera horizontally and
look at the viewfinder.
Keep looking at the blinking
focusing point in the viewfinder
and press the shutter button.
* The right-most focusing point will blink
first. While looking at the blinking
focusing point, press the shutter button.
* During this calibration procedure,
pressing the shutter button
completely will not take a picture.
» When you press the shutter button,
the focusing point will stop blinking
and stay lit and the beeper will sound.
* Keep looking at the focusing point
until the beeper sounds.
* If the beeper has been disabled
(page 77), it will not sound during
this calibration procedure.
Let go of the shutter button.
Repeat steps
and
> Do the same steps for focusing
points @) to @ which will blink in turn.
Check the viewfinder display.
» When the calibration is completed,
the CAL No. will stop blinking and
"End" will be displayed.
¢ If you take too long during the
calibration procedure and the blinking
focusing point turns off, press the
shutter button and start from step
Advertisement
Table of Contents
