Page 2
Install the floor stand 1. Insert the First extension (A) onto the Second 2. Let the cable jack of the Extension cable pass extension (B), aligning the slot in between. through from the back of the base. Make sure the DC socket is out on opening of the Second extension and ready for connection.
Page 3
6. Pass the cable jack through the Second 5. Pass the cable jack through the connector (J) extension (B), to the opening. pipe, then connect the pipe with the third Then connect the Second extension to the pole. connector (J) pipe. 7.
Page 4
8. Place the floor stand near the crib. Open the base cover, and put the water bag into the base to prevent the stand from falling. Then, cover the base cover.
Page 5
9. Install the Baby Unit onto the First extension (A). Connect the adapter to the end of the cable and the power supply to power up the Baby Unit. Slide the switch to ON to power your Baby Unit on. Floor stand installation is completed.