Advertisement
DISASSEMBLY
(3) How to remove the LOADING MOTOR.
SLIDE PLATE
1. Remove the SPECIAL WASHER
which fasten
the GEAR LA
and GEAR LB(C5}) . The
GEAR LA and GEAR LB can be removed.
2. Moving the slide plate C €15)to the right, lower the
elevator to the third slot position.
3. Remove the two screws (SCR S-TPG PAN PCS 2
2.5)
which fasten the LOADING MOTOR
=
LOADING
The LOADING MOTOR can be removed.
|
MOTOR
2) How to remove the PICKUP and the SPINDLE MOTOR.
(1) How to remove the CD PCB and PICKUP.
1. Short the short-pattern of FPC, PUC99 with solder.
2. Remove CS903, FPC602, CP904, CP905 and
CP906 from the connector.
3. Remove the two screws (SCR S-TPG PAN PCS 2 x
4) (72) and one screws (SCR S-TPG BIN 27)
(C73) which fasten the CD PCB (cB.
4. Remove the screw (SCR S-TPG BIN 2X7)
which fix INSIDE SWITCH
@ 7 8 ) .
5. Remove the two screws
(SCR PAN PCS 1.7 3.5)
|
and THRUST, SCREW (96), PLATE,
SLIDE Es? will come off.
6. Remove the two screws SPECIAL SCREW
which fix SHAFT, PICKUP, A839).
FPC PU
Short circuit soldering.
7. Remove the SHAFT, PICKUP, A
from the
PICKUP, LASER €87).
PICKUP. LASER
The PICKUP, LASER
can be removed.
short circuit
position.
8. Cause short circuit by soldering in PICKUP, LASER
|
Cause shor circuit on the PICKUP, LASER (87)
_ Remove FPC, PU CD off CONNECT, and CD
Hevea raha
ea
oy
<e)
Advertisement
