Kenmore 721.80002 Installation Instructions Manual page 16

STEP 5: INSTALL THE MOUNTING PLATE TO THE WALL
TO PREPARE THE REAR WALL CUTOUT
OPENING AND EXHAUST ADAPTOR/
MOUNTING PLATE FOR WALL VENTING
AND ROOF VENTING:
NOTE: If room vented installation is used, skip this step.
1. Using the Wall-template. This template will give the i :
location and size of the box cutout for the rear wall : Go '
duct as described in step 5 item I(page 15) OO. -
. Using a pencil, put dots through slots "F"and "G",
and through holes "H" and "I". Remove the mounting Figure 28
plate and draw lines extending through the points.
This will give the location and size of the box cutout
for the rear wall duct. See Figure 28.
* Attach the exhaust adaptor to the rear mounting
plate by sliding it into the guides at the top center
of the plate on the wall side. Push in securely unti Adapto
lit is past the top locking tabs and in the lower
locking tabs. Take care to assure the damper
hinge is installed so that it is at the top and that Slide exhaust
the damper swings freely. adaptor into
guides on rear |
Ae
2
aa
()
Z
ve
ge Damper
(hinge side up)
Mounting Plate
(wall side)
* Carefully guide the exhaust adaptor, now atached Panel. "A
to the mounting plate, into the house duct, before J
using the screws to attach the plate to the wall.
This will assure proper alignment for installation.
See Figure 29.
Guide
Figure 29
* Return to step 5, item 3 (page 15) to continue.
After completing the installation of the mounting
plate, again check the rear damper for free
movement to assure it will operate properly.
16