Sawing; Plunge Cuts; Selection Of Sawblade; Motor Unit With Multifunction Tool Pkga4 - Parkside PKGA 20-Li C2 Translation Of The Original Instructions

Sawing

­ Wear­eye­protection.
• Use only undamaged sawblades in
perfect­condition.­Only­use­metal­saw-
blades­for­metalworking.
•­ Ensure­your­stance­is­stable­and­hold­
the­appliance­tightly­with­both­hands­
and away from your body.
•­ Before­sawing­the­workpiece,­check­
for hidden foreign objects such as
nails, screws. These must be removed.
• Plunge cuts may only be made in soft
material­such­as­wood­or­plaster-
board.

Plunge cuts

Risk of kickback! Hold the
device firmly.
1. Place the device with the bottom edge
of­the­footplate­(17)­on­the­workpiece.
2. Turn on the device.
3.­ Insert­the­saw­blade­(19/20)­in­the­
workpiece­by­tipping­the­device­for-
ward until the device is vertical.
4.­ Continue­sawing­along­the­desired­cut-
ting line.

Selection of sawblade

Wood sawblade
Metal­sawblade
Plunge sawblade
for­wood,­plastic,­plaster-
board
for­metal­sheets,­profiles­
and tubes
for­soft­materials­like­
wood­or­plasterboard
Motor unit with
multifunction tool
PKGA4
­ Wear­a­protective­mask­during­
grinding­work.
Changing­the­tool
Secure the appliance against
switching on (see "Switch­
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
­ Ensure­that­the­tool­holder­(29)­is­
tightly screwed in to ensure you can
safely­mount­and­use­all­the­sup-
plied­tools­(30/32/33).
1.­ Push­the­lever­(27)­for­tool­unlocking­
upwards­as­far­as­the­stop.
2.­ Place­the­desired­tool­(30/32/33)­be-
low­the­tool­holder­(29)­on­the­arbors­
(28).­You­may­need­to­rotate­the­un-
locked­tool­holder­(29)­as­far­as­need-
ed­to­allow­you­to­place­the­desired­
tool­(30/32/33)­onto­the­arbors­(28).­
12­different­positions­are­possible.
3. Rotate the tool holder as required until
it­is­firmly­in­place.
4.­ Push­the­lever­(27)­for­tool­unlocking­
forwards again. The tool holder is
fixed­to­the­tool.
Attaching/removing­sanding­
sheet
The­delta­sanding­plate­(30)­is­fitted­with­Vel-
cro­for­rapid­attachment­of­the­sanding­sheet.­
Attaching sanding sheet
1.­ Press­the­sanding­sheet­(31)­evenly­
onto­the­delta­sanding­plate­(30).­En-
GB MT
41