Class 1 Laser Product - Samsung BD-P1400 User Manual

,safety nformat on
J
WARNING
TO REDUCE THE RISK OF ELECTRICSHOCK, DO NOT REMOVE THE COVER(OR BACK).
NO USER-SERVICEABLEPARTS ARE INSIDE. REFER SERVICING TO QUALIFIEDSERVICE PERSONNEL.
Thelighting flashandArrowhead w ithin
Triangle is awarning signalerting youof
dangerous voltage inside the product
CAUTION
CAUTION: TOREDUCE THE RBKOFELECTRIC
SHOCK, DONOT REMOVE COVER ( OR BACK) NO
USER SERVICEABLE PARTS I NSIDE. REFER
SERVICING TOQULAIFIED SERVICE PERSONNEL.
Theexplanation p ointwithinthetriangle
isa warning signalerting youof
important instructions accompanying
the product.
WARNING
,, To reduce the risk of fire or electric shock, do not expose this appliance to rain or moisture.
,, To preventinjury,thisapparatusmust be securelyattachedto the floor/wall inaccordancewiththe installationinstructions.
,, Ifthis power supply is used at 240V ac, a suitable plug adapter should be used.
Note to CATV system installer
This reminderis provided to call CAW system instalbr's attention to Article820-40 of the NationalElectricalCode (Section
54 of CanadianElectricalCode, Part I)that providesguidelinesfor proper grounding and, inparticular, specifiesthat the
cable ground shall be connected to the groundingsystem of the buildingas close to the point of cable entry as practical.
FCC NOTE (for U.S.A):
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15
of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on.
The user is encouraged to try to correct the interference by one or more of the following measures.
,, Reorient or relocate the receiving antenna.
,, increase the separation between the equipment and receiver.
,, Connect this equipment into an outlet on a circuit different from that to which the receiver is connected.
,, Consult the dealer or an experienced radio/TV technician for help.
This class B digital apparatus meets all requirements of the Canadian Interference - Causing Equipment
Regulations.
CLASS 1 LASER PRODUCT
Use of controls, adjustments or performance of procedures other than those specified herein may result in
hazardous radiation exposure.
CAUTION
THIS PRODUCTUTILIZES A LASER. USEOF CONTROLS OR ADJUSTMENTS OR PERFORMANCEOF
PROCEDURESOTHER THAN THOSE SPECIFIEDHEREIN MAY RESULT IN HAZARDOUS RADIATIONEXPOSURE.
DO NOT OPEN COVERAND DO NOT REPAIRYOURSELF. REFERSERViCiNG TO QUALiFiED PERSONNEL.
safety nforrmation