Installation And Connections; Installation; Removing Protective Spacers For Transportation - TAD -M700 Owner's Manual

INSTALLATION AND CONNECTIONS

Installation

WARNING
 As the unit is a large and heavy unit, make sure to move, unpack and install with four or more people.
 When installing, choose a level and flat surface that can sufficiently withstand the weight of this unit. Failure to do so
could cause the unit to fall, resulting in an accident.
It is recommended that the unit be installed directly on a solid floor surface. If installed on a shelf, the user is
responsible for confirming that the location is fully able to support the heavy weight of the amplifier.
 To promote heat-emission, do not put objects on top of this unit or cover with a sheet (such as cloth or curtains) while
operating. Failure to do so could cause the unit to malfunction through abnormal heating.
CAUTION
Install the unit with open space for at least 60 cm from the top surface and 10 cm from rear surface as well as at
least 30 cm from sides, to ensure sufficient clearance to dissipate heat. Failure to do so may result in heat being
trapped inside the unit, which can cause malfunction.
CAUTION
 As the unit emits a large amount of heat, do not place this unit on top of soft surfaces (such as carpeting or cushions)
or in small spaces.

Removing Protective Spacers for Transportation

Remove protective spacers for transportation when installing the product. Protective spacers are easily removed by
holding and pulling the tape tab while lifting the product.
CAUTION
 Since the product is heavy, lift one corner at a time to remove protective spacers.
Leave 60 cm open
Protective spacer
TAD-M700 / TAD-M700S
9