Table of Contents
Advertisement
03 CONNECTING THE
SOUNDBAR
Connecting the power and units
fil
Rear of Subwoofer
Sound bar Main Unit
Manually connecting the Subwoofer
or Surround Speakers
1. Turn off the Sound bar main.
2. Press and hold ID SET on the rear of the subwoofer and
surround speakers for at least 5 seconds.
•
The surround speakers may not be provided,
depending on the model.
Rear of Subwoofer
"Blinking blue fast"
3. Press the
Up
button on the remote control for
5 seconds .
..
4.
Check if the LINK LED is solid blue (connection
complete).
•
The LINK LED indicator stops blinking and glows a
solid blue when a connection is established between
the Sound bar and the Wireless Subwoofer, surround
speakers.
Connecting an SWA-9100 to your
Soundbar
1. Connect the Wireless Receiver Module to 2 Surround
Speakers
Use the speaker cables to connect the two surround
sound speakers to the Wireless Receiver Module.
2. Check the standby status after plugging into an
electrical outlet
The LINK LED indicator (blue LED) on the Wireless
Receiver Module blinks. If the LED does not bli nk, press
the ID SET button on the back of the Wireless Receiver
Module with a pen tip for 5-6 seconds unt il the LI NK
LED indicator blinks (in Blue).
■
..
"Blue
3. Configure
"ID SET" using the Soundbar's remote control
Turn off the Sound bar main. Press the Up button on the
remote control for 5 seconds.
""' W-.. """"- .
T
~.__.. .... _ . , . .
t
.... - - ~ - . , •
~
➔
- - -
.
·~
--
·~·
.,..-:~--
4. Check if the LINK LED is solid blue (connection
complete)
Advertisement
Table of Contents
