Panasonic Digital Palmcorder PV-DV52 Operating Instructions Manual page 11

POWER
Connect and plug in the Power Cord
as shown.
• POWER Lamp will light.
• Remove the DC Cable, if attached,
from the adaptor.
Attach the Battery as shown to
charge.
• CHARGE Lamp lights up. It goes out
when charging is complete (approx.
1 hour). Expect approx. 1 hour
30 minutes of operation (EVF usage)
when fully charged.
Remove the Battery.
Slide the Battery out and then lift up.
I _RF3
About the Flashing of the CHARGE Lamp
• Charge the Battery within an ambient temperature range of t 0 °C (50 °F) and
30 °C (86 °F).
• If charging is done in extreme low or high temperatures, Battery charge time increases.
CHARGE Lamp flashes when...
• The Battery is being charged, but charging is taking longer than normal.
• Charging is not possible. Remove the Battery once, wait a short time, then re-attach it
for charging.
I I,_-[_. i i,-[:]I=nt(=_A,J ¢J_J:,
I _[;1 i l [o]qNi | n'l_l "El | (;t ivl _/_.[_1[4
BATT RELEASE
Insert the Battery Pack and slide it up | Tilt Viewfinder upward.
4
until it locks with a click.
Remove the Battery Pack and slide
the Battery downward while sliding the
BATT RELEASE.
11