Please contact your Toyota
dealer with any questions or
concerns.
■
Auto current cut-off function
In case of over current, the auto cut-
off function stops the power flowing
to the trailer lights to prevent dam-
age to the vehicle's electrical sys-
tem.
This function is activated when the
rated current of any of the following
trailer light circuit components is
exceeded:
●
Stop/turn signal light (right): maxi-
mum 5 A
●
Stop/turn signal light (left): maxi-
mum 5 A
■
When the auto current cut func-
tion is activated
If a trailer light does not come on
due to the activation of the auto cur-
rent cut function, the light system
will need to be reset.
Follow the reset procedure shown
below.
●
If a tail light does not come on,
turn off the headlight switch.
●
If the right-side stop/turn signal
light does not come on, put the
turn signal in the off position or
remove foot from the brake pedal.
●
If the left-side stop/turn signal light
does not come on, put the turn
signal in the off position or remove
foot from the brake pedal.
If the emergency flashers do not
Owners Manual_USA_M04041_en
4-1. Before driving
operate, press the emergency
flasher switch to turn them off.
After the light system is reset, oper-
ate the light switches again to see if
the lights operate normally.
If the lights do not operate normally,
have the vehicle inspected by your
Toyota dealer.
■
Trailer lights operation check
function
Use the meter control switches to
start the function. (P.99, 108)
Vehicles with 7-inch display
1
Press
or
of the meter
control switch to select
2
Press
or
to select "Vehi-
cle Settings" and then press and
hold
.
3
Press
/
to select "Trailer
Light Check" and then press
.
4
Press
to start the trailer light
check.
Vehicles with 12.3-inch display
1
Press and hold
the cursor on the content display
area (center) of the multi-infor-
mation display. (P.108)
2
Press
or
of the meter
control switches to select "
Settings" and then press
3
Press
or
to select "Vehi-
cle Settings" and then press and
hold
.
207
.
4
to display
.