Table of Contents
Advertisement
REMOTE CONTROL
© Recording start/stop button (REC START/STOP)
© Rewind/Reverse search button (<@REW)
© Still button (HISTILL)
© On-screen display button (DATA ON SCREEN)
© Counter reset button (COUNTER RESET)
© Counter memory button (COUNTER MEMORY)
@ Scene search buttons (- SCENE SEARCH +)
@ Fast-forward/Forward search button (FFP )
© Stop button (EISTOP)
@ Playback button (PLAY )
Inserting the batteries
Open the battery compartment lid, and insert two AA 1.5
volt batteries (Sold separately), respecting the (+) and (-)
polarity indicated inside the battery compartment.
Close the battery compartment lid.
ENGLISH
'1 In camera mode, set the stand-by switch on the
2 Aim the remote control unit at the infrared remote
+
control sensor on the camcorder, then press the
Naana
AAT
z
Sas
a
15
i
i
i
A
i
:
;
light.
$
i
i
Operate the remote control unit from within approximately
5 m (16 ft) and within a range of 30° from the front of the
camcorder. If the operating range decreases, replace the
batteries.
Wee
camcorder to the "READY" position.
_
ee
eee
et
gro
an
$
$
i
desired button to operate.
During recording, the recording indicator (A) will
It will flash during a recording pause.
VAa AALALA na na
a esa
ey at
SAE
SARNIA EAEOI
RNAS ARE ARON
t
Notes:
@ To prevent battery leakage, remove the batteries if the
remote control unit is not to be used for a long period of
time.
When the batteries need to be changed, make sure to
replace both batteries with new ones.
@ Remote control operation is not possible if:
m a strong light or sunlight is directed to the remote
control sensor,
a there is any obstacle between the remote control unit
and the camcorder.
@ In camera mode, if a recording pause continues for
more than 5 minutes, the recording indicator (A) goes
off and the power is cut to prevent the tape from being
damaged. To resume recording press the
REC START/STOP button twice. If pressed only once,
the unit will return to recording pause mode.
Advertisement
Table of Contents
