Advertisement
>
TROUBLESHOOTING
WHEN A LASERVISION DISC IS BEING PLAYED
Symptom
Cause
Remedy
5. Disc is rotating but there is no
e The TV set is not turned on.
e Turnon TV.
picture.
e Wrong connections from player to TV.
e
Make correct connections.
6. Picture continuously
moves
e
The TV vertical-hold control is not adjusted
| e
Adjust vertical-hold control on TV.
vertically.
properly.
7. Particular
disc
does
not
playback
properly.
The
playback stops in the middle
of the disc program.
e
The playing surface of the disc is dirty.
e
Use a soft cloth and lightly wipe off the dirt from
the surface of the disc. If necessary, moisten a
cloth with diluted neutral detergent to remove
heavy dirt or fingerprints.
e The disc is warped.
e@ Change the disc.
8. Sound
is
unnatural
or
e CX system is turned ON for disc which has no | @
Press AUDIO D/A to turn CX system OFF.
distorted.
OX mark.
e
MULTI-SPEED or STILL/STEP playback is
being performed. Sound is output only during
the normal play mode. The audio signals are
not output during other playback modes.
9. No
sound
output
during
playback.
e
Press PLAY & to set the player to normal play
mode.
10.During STILL playback, a part
of the screen image shakes.
Even if the disc is a standard play disc, there may
be some cases in which a fully still image cannot
be obtained, but this does not mean that the
player or the disc is defective.
11.CHAPTER
SKIP, CHAPTER
PROGRAM
PLAY
and
CHAPTER NUMBER SEARCH
cannot be performed.
@
Disc in which no chapter numbers are recorded
is loaded.
Press DISPLAY to check if chapter number is
displayed.
e
|t takes time to read the recorded code,
depending on the disc.
12.Certain discs take too long to
search or are not searched.
Press CLEAR and picture will appear.
(At this point, a slightly different scene from that
which has been searched for may appear.)
e@ There are errors when the disc code is read.
(There is no damage to the unit.)
13.Certain discs take too long to
start or do not start.
e
Press
and stop the playback. Press PLAY »
and start the playback again. (Repeat this
operation a few times.)
Same as item 12 above.
(The repeat mode is canceled.)
14.The player takes too long to
e
Same as item 12 above.
find point A-B (INTERVAL)
REPEAT operation.
15.Picture other than instructed
is searched in TIME NUMBER
SEARCH mode.
e
Method of inputting numerals in the TIME NUMBER SEARCH mode differs, depending on whether
time number is recorded on disc in hours and minutes or minutes and seconds as shown below:
[e.g.] 12-minute search
e
Disc in which time number is recorded in minutes.
"minutes"
e
Disc in which time number is recorded in minutes and seconds.
[enem A.L]
"minutes"
"seconds"
21
<VRB1141>
En
Advertisement
