Safety Regulations - Stiga SBC 627 K Operator's Manual

20. Harness
a. with single belt
b. with double belt
c. with backpack
21. Angle transmission
22. Blade protection (for transport)
23. Spark plug
31. Engine stop switch
32. Throttle control
33. Throttle lockout
34. Starter grip
35. Choke
36. Primer
37. Throttle shutter (if provided)
38. Fuel mixture tank cap
The example of the conformity declaration is
found in the penultimate page of the manual.
DESCRIPTION OF EXPLANATORY
SYMBOLS (where applicable)
41. Fuel mixture tank
42. Engine stop switch positions
a = stop
b = running
43. Choke
44. Cutting device with adequate protection
45. Cutting device rotation direction
SAFETY REQUIREMENTS
Your machine must be used carefully. Symbols
have therefore been placed on various parts of
the machine to remind you of the main precau-
tions to be taken. Their meaning is explained
below. You are also asked to carefully read the
safety regulations in the specific chapter of this
manual.
Replace damaged or illegible labels.
51. Warning! Danger. The failure to use this ma-
chine correctly can be hazardous for oneself
and others.
52. Read the instruction manual before using
the machine.
53. Anyone operating the machine under nor-
mal conditions for continuous daily use may
be exposed to a noise level equal to or ex-
ceeding 85 dB (A). Wear ear protectors,
safety goggles and a protective helmet.
54. Wear gloves and protective footwear!
55. Projectile object hazard! Keep any people
or pets at least 15 m away when using the
machine!
All manuals and user guides at all-guides.com
56. Maximum cutting device speed. Only use
57. Do not use circular saw blades. Danger:
58. Warning! Petrol is flammable. Allow engine
59. Beware of blade thrust.
60. Warning! - The engine emits carbon monox-
TECHNICAL DATA AND ACCESSORIES
[71] Mass
[72] Engine
[73] 2-stroke air-cooled
[74] Capacity / Power
[75] Engine rotation speed when idling
[77] Maximum tool rotation speed
[78] Fuel tank capacity
[79] Spark plug
[80] Fuel mixture (Petrol: 2-stroke oil)
[81] Maximum diameter allowed for blades with
[82] Maximum diameter allowed saw blade
[83] Operator ear noise pressure level
[84] Measurement uncertainty
[85] Measured acoustic power level
[86] Vibrations transmitted to the hand
[87] Vibrations transmitted to the hand
[88] Vibrations transmitted to the hand
[89] Vibrations transmitted to the hand
[90] Guaranteed acoustic power level
[91] Cutting device code
[92] Protection code
[93] Availability:
1) Read the instructions carefully. Become ac-
quainted with the controls and the proper use
of the machine. Learn how to stop the engine
quickly.
2
suitable cutting devices.
Using circular saw blades with ma-
chines marked with this symbol expos-
es the user to the danger of very serious
or even fatal injuries.
to cool at least 2 minutes before refuelling.
ide. DO NOT start up in an enclosed area.
3 or 4 points
on the front handgrip
on the rear handgrip
on the left handgrip
on the right handgrip
X = standard machine feature
O = optional, available on request
(–) not provided

SAFETY REGULATIONS

to be observed scrupulously
A) TRAINING