Table of Contents
Advertisement
• As illustrated, pull the film leader out so that its
end aligns with the © film leader end mark
{red bar); in other words, bring the film leader end
within the length of the bar.
• Make sure that the perforations on the bottom
side of the film have engaged the © sprocket
teeth as well as the O spool teeth.
• Also make sure that the film is properly placed
between the two
G
guide rails.
• Take up any slack left in the film so that the film
is flat as shown, by rewinding it slightly into
the cartridge.
• When a film with a higher ISO number is loaded,
do not leave the camera out of the case for
a long time.
15 •
Advertisement
Table of Contents
