Sylvania W3913LC Owner's Manual page 18

CABLE WITH CONVERTER/
DESCRAMBLER BOX OR SATELLITE BOX
EXTERNAL INPUT MODE
If your cable service supplies you with a converter box
or if you use a satellite system, you can use the basic
connection shown here.
By using this connection you can also record scrambled
channels. However, channel selection must be made
with the converter box or satellite box. This means that
channels cannot be changed using the TV/VCR Remote
Control. Unattended timer recording is limited to one
channel at a time.
When using an external input signal (another VCR or
video camera), connect the player's audio/video output
cables to the AUDIO IN/
VIDEO IN jacks of your
TV/VCR. Then press the
CHANNEL A or Y button
until "AUX" appears on the
screen.
—
Satellite Box or
Cable Box (Not supplied)
From Cable System
* or Satellite Dish
A
75-ohm Coaxial
Cable
(Not supplied)
ANT.
[Fig.7]
TO RECORD A SCRAMBLED/UNSCRAMBLED
CHANNEL
1. Set the TV/VCR channel selector to the output
channel of the Cable Converter Box or Satellite Box.
(Ex. CH3)
2. Select the channel to record from your Cable
Converter Box or Satellite Box.
INSTALLING THE BATTERIES
1) Open the battery compartment cover by pressing the
cover on the remote unit in the direction of the arrow.
2) Insert 2 "AA" penlight batteries into the battery
compartment in the direction indicated by the
polarity (+/-) markings.
3) Replace the cover.
USING THE SWIVEL
CAUTION:
Always place the swivel on a flat surface.
1) Carefully place the TV/V CR upside down and attach
the assembled swivel to the bottom of the TV/VCR
as shown.
2) Put the screw (supplied) into the holes marked by the
arrow.
[Fig-8]
3) Place the TV/V CR right-side up. Y ou now can rotate
the TV/VCR in either direction.