Getting Started - AMERITECH vt1933 Owner's Manual

GETTING STARTED

• Plug the AC POWER ADAPTER into a
live electrical outlet and the DC POWER
CONNECTOR into the back of the Base
Unit.
AC
OUTLET
11V DC TEL.LINE
• Slide the Handset battery cover down,
and remove it from the Handset.
PRESS and SLIDE
DOWNWARD
• Install the BATTERY PACK, with the
metal contacts facing down and aligned
with the Handset contacts. Replace
Handset battery cover.
PLEASE NOTE THE
CORRECT POSITION
OF THE BATTERY
PACK WHEN INSTALLING
SLIDE IN THE
BATTERY
COVER
• Place the Handset into the Base Unit
cradle. Make sure the Charging light is
illuminated. Charge for at least 16
hours before first using the phone.
The Handset can charge face up or
down.
• Set the TONE/PULSE switch, located
on the antenna side of the Base Unit,
to the desired dialing mode. In most
areas, TONE is the desired mode.
RINGER
OFF LOW HI PULSE TONE
6
GETTING STARTED
• After charging the battery pack, con-
nect the telephone line cord to a live
telephone outlet and the TEL. LINE
jack, located on the back edge of the
Base Unit.
• If your Base Unit is not connected to a
live telephone outlet, the Handset will
display:
TELEPHONE
WALL JACK
11V DC TEL.LINE
For best results, raise the antenna on the
Base Unit and Handset when using
the phone.
7